Hay Rack with Beater

Their structure is hot-dip galvanised after assembly.

They are factory fitted with:

- bottom sheets reinforced by two cones to center round bales, with the ends drilled with several holes to evacuate moisture,

- ‘optimum’ roof, with a wide curve to improve the installation of large hay bales and a larger covered surface to better protect them from the rain,

- the height of the roof and pads can be adjusted by through bolts,

- folding tow bar (except RTT, U bar using the five rails),

- monoblock hitch panel to reduce assembly time and contribute to the structure’s strength. 

These hay racks are perfect for the distribution of round fodder bales in pastures.

The drop panel hay rack is fitted with:

- 2 drop panels to avoid fodder waste,

- wither bars preventing animals from accessing the interior of the hay racks on the drop panel side.

Ø 25 mm bars mechanically welded after fitting in the lower and upper tubes for added strength.